![]() ![]() After the device is connected to the remote desktop, reinsert the SD card again to make the disk volume appear in the remote desktop. Workaround: Reinsert the SD card into the Transcend card reader. Because the SD card is not mounted on your Mac client system, the device does not appear in the menu in Horizon Client and you cannot use the USB redirection feature to connect the device to the remote desktop. When you insert an SD card into a Transcend USB 3.0 card reader attached to your Mac client system, the SD card is not mounted automatically. From the Horizon Client menu bar, select Desktop > USB > Autoconnect USB Devices on Insert. Workaround: Configure Horizon Client to automatically connect the device when you insert it. The remote desktop shows that a new drive was added and so displays a new drive letter but no corresponding label to identify the device. For example, after you redirect the device to the remote desktop, the password prompt does not appear. If you use the PCoIP display protocol, connecting some password-protected storage devices (such as IronKey USB flash drives) might not work correctly. Resolved Issues The number provided before each resolved issue refers to the VMware internal issues tracking system. Beginning with Horizon Client for Mac 2006, Virtual Printing (also known as ThinPrint) is not supported. ![]() For system requirements and installation instructions, see the VMware Horizon Client for Mac Installation and Setup Guide document.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |